A work by Laura A Dima. Mechanical design, production drawings and fabrication by me, 2026. Everything but the two circuit boards: the one in the dome and the motor controller.
A commission: Laura’s idea and brief, built as a working object.
What I designed and made
- a 3D-printed dome and housing, fitted around the board
- eight LEDs set into the ribs of the dome
- laser-cut plexiglass
- solenoids and their mounts
- a lower layer carrying six motors and three drivers
From model to parts
Everything was modelled in Shapr3D, with the circuit board in the model. From there it went out as 3MF for printing, sliced with per-part settings to Laura’s specification, and as DXF and DWG production drawings for laser cutting.
Working renders in Shapr3D, LEDs lit. From above (top) and from below (here).
Eighteen versioned stages in six weeks
- July 2026: two-part and four-part assemblies, and a faster dome-only print
- 4–5 August: the bottom with two keys, the disk, the dome
- 7–16 August: the dome with six LEDs, then eight, over three versions
- 20–26 August: the bottom box, a small test print, and the solenoid fit, adjusted twice
- 24 August: the plexiglass drawing for laser cutting
- 26–27 August: the second layer, with six motors and three drivers, tested
- 31 August: the lid